Meitnerium is a synthetic chemical element; it has symbol Mt and atomic number 109. It is an extremely radioactive synthetic element (not naturally occurring, but can be created in a laboratory). The most stable known isotope, meitnerium-278, has a half-life of 4.5 seconds, although the unconfirmed meitnerium-282 may have a longer half-life of 67 seconds. The element was first synthesized in August 1982 by the GSI Helmholtz Centre for Heavy Ion Research near Darmstadt, Germany, and it was named after the Austrian-Swedish nuclear physicist Lise Meitner in 1997.
In the periodic table, meitnerium is a d-block transactinide element. It is a member of the 7th period and is placed in the group 9 elements, although no chemical experiments have yet been carried out to confirm that it behaves as the heavier homologue to iridium in group 9 as the seventh member of the 6d series of transition metals. Meitnerium is calculated to have properties similar to its lighter homologues, cobalt, rhodium, and iridium.
Introduction
History
Discovery Meitnerium was first synthesized on August 29, 1982, by a German research team led by Peter Armbruster and Gottfried Münzenberg at the Institute for Heavy Ion Research (Gesellschaft für Schwerionenforschung) in Darmstadt. The team bombarded a target of bismuth-209 with accelerated nuclei of iron-58 and detected a single atom of the isotope meitnerium-266: (Note: for Part I see Pure Appl. Chem., Vol. 63, No. 6, pp. 879–886, 1991)
+ → +
This work was confirmed three years later at the Joint Institute for Nuclear Research at Dubna (then in the Soviet Union).
Naming
In Mendeleev's nomenclature for unnamed and undiscovered elements, meitnerium would be called eka-iridium. In 1979, during the Transfermium Wars (but before the synthesis of meitnerium), IUPAC published recommendations per which the element was to be called unnilennium (symbol Une), a systematic element name as a placeholder, until the element is discovered (and the discovery then confirmed) and a permanent name is decided on. Though widely used in the chemical community on all levels, from chemistry classrooms to advanced textbooks, the recommendations were mostly ignored among scientists in the field, who either called it "element 109", with the symbol E109, (109) or even simply 109, or used the proposed name "meitnerium".
The naming of meitnerium was discussed in the Transfermium Wars regarding the names of elements 104–109, but meitnerium was the only proposal and thus was never disputed. The name meitnerium (Mt) was suggested by the GSI team in September 1992 in honor of Austrian physicist Lise Meitner, a co-discoverer of protactinium (with Otto Hahn), and one of the discoverers of nuclear fission. In 1994 the name was recommended by IUPAC, and was officially adopted in 1997. It is thus the only element named solely after a non-mythical woman (curium is named for both Pierre and Marie Curie)."Meitnerium is named for the Austrian physicist Lise Meitner." in Meitnerium in Royal Society of Chemistry – Visual Element Periodic Table . Retrieved August 14, 2015.
Isotopes
Meitnerium has no stable or naturally occurring isotopes. Several radioisotopes have been synthesized in the laboratory, either by fusing two atoms or from the decay of heavier elements. Eight isotopes of meitnerium have been reported with mass numbers 266, 268, 270, and 274–278, two of which, Mt and Mt, have unconfirmed metastable states. A ninth isotope, Mt, is unconfirmed. Most of these decay by alpha emission, though some undergo spontaneous fission.
Stability and half-lives
All meitnerium isotopes are extremely unstable (radioactive); in general, heavier isotopes are more stable than the lighter. The most stable known isotope, 278Mt (half-life 4.5 seconds), is also the heaviest known. The unconfirmed 282Mt is even heavier and seems to have a longer half-life, 67 seconds. With a half-life of 0.8 seconds, the next most stable known isotope is 270Mt. 276Mt and 274Mt have half-lives of 0.62 and 0.64 seconds respectively.
277Mt, created as the final decay product of 293Ts for the first time in 2012, was observed to undergo spontaneous fission, half-life 5 milliseconds. Preliminary data analysis considered the possibility that this fission is instead from 277Hs, for it also has a half-life of a few milliseconds, and could come from undetected electron capture somewhere in the decay chain. This possibility was later deemed very unlikely based on observed decay energies of 281Ds and 281Rg and the short half-life of 277Mt, although there is still some uncertainty of the assignment. Regardless, the rapid fission of 277Mt and 277Hs is strongly suggestive of a region of instability for superheavy nuclei with N = 168–170. The existence of this region, characterized by a decrease in fission barrier height between the deformed shell closure at N = 162 and spherical shell closure at N = 184, is consistent with theoretical models.
Predicted properties Other than nuclear properties, no properties of meitnerium or its compounds have been measured; this is due to its extremely limited and expensive production and the fact that meitnerium and its parents decay very quickly. Properties of meitnerium metal remain unknown and only predictions are available.
Chemical Meitnerium is the seventh member of the 6d series of transition metals, and should be much like the platinum group metals. Calculations on its ionization potentials and atomic and ionic radii are similar to that of its lighter homolog iridium; implying that meitnerium's basic properties will resemble those of the other group 9 elements: cobalt, rhodium, and iridium.
Prediction of the chemical properties of meitnerium has not received much attention recently. Meitnerium is expected to be a noble metal. The standard electrode potential for the /Mt couple is expected to be 0.8 V. Based on the most stable oxidation states of the lighter group 9 elements, the most stable oxidation states of meitnerium are predicted to be +6, +3, and +1, with the +3 state being the most stable in aqueous solutions. Rhodium and iridium show a maximum oxidation state of +6; the most stable states are +4 and +3 for iridium and +3 for rhodium. The oxidation state +9, represented only by iridium in , might be possible for meitnerium nonafluoride and the cation, though is expected to be more stable than these meitnerium compounds. The meitnerium tetrahalides have also been predicted to have similar stabilities to those of iridium, thus also allowing a stable +4 state. It is further expected that the maximum oxidation states of elements from bohrium (element 107) to darmstadtium (110) may be stable in the gas phase but not in aqueous solution.
Physical and atomic Meitnerium is expected to be a solid under normal conditions and assume a face-centered cubic crystal structure, similarly to its lighter congener iridium. It should be a very heavy metal with a density of around 27–28 g/cm3, which would be among the highest of any of the 118 known elements. Meitnerium is also predicted to be paramagnetic.
Theoreticians have predicted the covalent radius of meitnerium to be 6 to 10 pm larger than that of iridium. The atomic radius of meitnerium is expected to be around 128 pm.
Experimental chemistry Meitnerium is the first element on whose chemistry has not yet been investigated. Unambiguous determination of its chemical properties is yet to have been established due to the short half-lives of meitnerium isotopes and a limited number of likely volatile compounds that could be studied on a tiny scale. One of the few meitnerium compounds that are likely to be volatile enough is meitnerium hexafluoride , as its lighter homolog iridium hexafluoride () is volatile above 60°C, so the analogous compound of meitnerium might also be volatile enough; a volatile octafluoride might also be possible. For chemical studies on a transactinide, at least four atoms must be produced, the half-life of the isotope used must be ≥1 second, and the rate of production must be at least one atom per week. Even though the half-life of 278Mt, the most stable confirmed isotope, is 4.5 seconds, long enough for chemical studies, another obstacle is the need to increase the rate of production of meitnerium and allow experiments to carry on for weeks or months so that statistically significant results can be obtained. Separation and detection must be carried out continuously to separate out the meitnerium isotopes and have automated systems experiment on the gas-phase and solution chemistry of meitnerium, as the yields for heavier elements are predicted to be smaller than those for lighter elements; some of the separation techniques used for bohrium and hassium could be reused. However, the experimental chemistry of meitnerium has not received as much attention as that of the heavier elements from copernicium to livermorium.
Lawrence Berkeley National Laboratory tried to synthesize 271Mt in 2002–2003 for a possible chemical investigation of meitnerium, as it was expected that it might be more stable than nearby isotopes due to having 162 neutrons, a magic number for deformed nuclei; its half-life was predicted to be a few seconds, long enough for a chemical investigation. However, no atoms of 271Mt were detected;Zielinski P. M. et al. (2003). "The search for 271Mt via the reaction 238U + 37Cl" , GSI Annual report. Retrieved on 2008-03-01 this isotope of meitnerium is currently unknown.
An experiment determining the chemical properties of a transactinide would need to compare a compound of that transactinide with analogous compounds of some of its lighter homologs: for example, in the chemical characterization of hassium, hassium tetroxide was compared with the osmium analog, osmium tetroxide . In a preliminary step toward determining the chemical properties of meitnerium, the GSI attempted sublimation of rhodium(III) oxide and rhodium(III) chloride . However, macroscopic amounts of the oxide would not sublimate until 1000°C and the chloride would not until 780°C, and then only in the presence of carbon aerosol particles: these temperatures are far too high for such procedures to be used on meitnerium, as most of the current methods used for the investigation of the chemistry of superheavies do not work above 500°C.
Following the 2014 successful synthesis of seaborgium hexacarbonyl, , studies were conducted with the stable transition metals of groups 7–9, suggesting that carbonyl formation could be extended to further probe the chemistries of the early 6d transition metals from rutherfordium to meitnerium inclusive. Nevertheless, the challenges of low half-lives and difficult production, make meitnerium hard to access for chemists, though 278Mt and 276Mt are long-lived enough for chemical research and may be produced in the decay chains of 294Ts and 288Mc respectively. 276Mt is likely more suitable, since producing tennessine requires a rare and rather short-lived berkelium target.270Mt, observed in the decay chain of 278Nh with a half-life of 0.69 second, may also be long-lived enough for chemical investigations, though a direct synthesis route leading to this isotope and more precise measurements of its decay properties would be required.
Notes
References
Bibliography
External links
Meitnerium at The Periodic Table of Videos (University of Nottingham)